Specifying The Current Software Versions - Extreme Networks EPICenter Reference Manual

The Firmware Manager
CAUTION
If you select Skip Multi-Step Upgrade, be sure that you fully understand all upgrade procedures. Skipping the multi-
step upgrade procedure may cause an error on the device and can cause the upgrade to fail.
After you upgrade the device(s), you should check each device configuration to be sure that the new
image has been properly loaded. You should also make any config
For more information on verifying the device, see the ExtremeWare Release Notes.

Specifying the Current Software Versions

The Versions window lets you specify the current version of the ExtremeWare software for each type of
Extreme Networks device.
This information is used by the EPICenter software to determine whether an individual device is
running the version you have specified as the "standard version." This is the version that appears in the
Standard Image column in the Hardware Selection page of the Upgrade Wizard. It is also used to
determine whether the image on a device matches the standard version as indicated by a check or an X
in the Software Versions and BootROM Versions column in the main Firmware Manager display.
Click the Versions button at the top of the Firmware Manager window to display the Configure
Standard version window, as shown in Figure 91.
Figure 91: Configure Standard version window
194
EPICenter Reference Guide