Acknowledging The Version Changes; Checking For Version Availability; Upgrading The Software Or Bootrom On Your Switches - Extreme Networks EPICenter Reference Manual

The Firmware Manager

Acknowledging the Version Changes

Once you have downloaded the software versions of interest to you, you can accept and acknowledge
the list of software image updates: this changes any green checks in the Change column to red X's. A
red X indicates that the version shown in the Software Image list has not changed since the last time
you viewed and acknowledged the list. Thereafter, green checks will appear only when you update the
software information list and changes in the list are detected—the changed images will be indicated
with a green check.

Checking for Version Availability

To check for the availability of new software versions and update the list, click Update Software
Information. This queries the Extreme server and updates the list in the Software Image field. Any
versions that have changed since you last acknowledged the update list now show a green check to
indicate the change.

Upgrading the Software or BootROM on Your Switches

ExtremeWare software images contains the executable code that runs on the switch and on certain
Extreme modules that include software. An image comes pre-installed from the factory on every switch
and on certain modules. You can upgrade this image by downloading a new version to the switch
through the Firmware Manager. You can download the image into either the primary or secondary
image, and specify whether the switch should be rebooted to immediately use the new image.
The BootROM software initializes certain important switch variables during the switch or module boot
process.
CAUTION
If a BootROM upgrade does not complete successfully, it could prevent the switch from booting.
EPICenter provides an Upgrade Wizard to help you select and download a new ExtremeWare software
image or BootROM image to a device or a module.
When you perform a software image upgrade, EPICenter automatically creates a backup of your
existing switch configuration. Switch configuration files for ExtremeWare are saved as text files in the
directory and configuration files for ExtremeXOS (along with Policy files, if any)
<tftp_root>\configs
are stored as zip files in the same location. is the location of the TFTP server, by default
<tftp_root>
. See Chapter 5 "Configuration Manager" for more
<EPICenter_install_dir>\user.war\tftp
information on where and how configuration files are stored, and how to restore them to a device if
necessary.
If you specify an upgrade to an image that is several revisions newer than the image running on the
switch, you may need to perform a multi-step upgrade; upgrade to an intermediate version before you
can upgrade to the more recent version. For "i-series" switches, the Upgrade Wizard evaluates the
switch and images you have specified, and will inform you if a multi-step upgrade is required. If a
multi-step upgrade is needed, EPICenter will inform you of the bootROM and image upgrades you
must perform to bring the switch to the version you have specified, and will proceed to perform the
first of those steps.
182
EPICenter Reference Guide