Table of Contents
Advertisement
Link/Act LEDs
The switch has LED indicators for Link and Activity. The LED will light steady green when
there is a secure connection (or link) to a 1000Mbps Ethernet device at any of the ports,
or steady orange when there is a secure connection (or link) to a 10/100Mbps Ethernet
device at any of the ports. The LED will blink green when a 1000Mbps port is active, or
blink orange when a 10/100Mbps port is active. The LED remains dark when there is no
link or activity.
PoE
The switch is equipped with a PoE LED. When this light is on with a solid green light, it
means that the corresponding ports are feeding power to the PoE devices plugged in.
When this light is on with a solid orange light, it means that the port is in an error
condition state. When this light is off, it means that the ports are not supplying power to
the devices plugged into the ports.
Rear Panel Description
The rear panel contains an AC power connector. The AC power connector is a standard three-pronged
connector that supports the power cord.
Figure 3: Rear Panel View of the EAS 200-24p
Plug-in the female connector of the provided power cord into this socket, and the male side of the cord
into a power outlet. The switch automatically adjusts the power setting to any supply voltage in the
range from 100~240VAC at 50~60Hz. The other port is available for future modification.
Side Panel Description
The system heat vents located on each side dissipate heat. Do not block these openings. Leave at least 6
inches of space at the rear and sides of the switch for proper ventilation. Be reminded that without
proper heat dissipation and air circulation, system components might overheat, which could lead to
system failure or even severely damage components.
Figure 4: Identical Side Panels of the EAS 200-24p
Extreme Networks EAS 200-24p Switch Hardware Installation Manual
LED Indicators
15
Advertisement
Table of Contents
