First Time Connecting To The Switch - Extreme Networks EAS 200-24p Switch Hardware Installation Manual

Figure 12: Boot up display in console screen
Boot Procedure
-------------------------------------------------------------------------------
Power On Self Test ........................................
MAC Address : 00-04-96-52-83-83
H/W Version : A1
Please Wait, Loading V1.00.006 Runtime Image ..............
UART init .................................................
Starting runtime image
Device Discovery ..........................................
Configuration init ........................................

First Time Connecting to the Switch

The switch supports user-based security that can allow prevention of unauthorized users from accessing
the switch or changing its settings. This section tells how to log onto the switch via out-of-band console
connection or out-of-band Management port connection.
Upon initial connection to the switch, the login screen appears (see example below).
Figure 13: Initial Screen, First Time Connecting to the Switch
EAS 200-24p Gigabit Ethernet Switch
Command Line Interface
Copyright(C) 2000-2011 Extreme Networks. All rights
UserName:
Enter the Username and Password and press Enter for both fields. Then access will be given to enter
commands after the command prompt EAS 200-24p:admin#
The default username for this switch is admin, and there is no password.
NOTE
The first user automatically gets Administrator level privileges. At least one Admin-level user account must
be created for the switch.
Extreme Networks EAS 200-24p Switch Hardware Installation Manual
Firmware: 1.00.007
reserved.
First Time Connecting to the Switch
V1.00.001
100 %
100 %
100 %
100 %
100 %
27