Programming Tl_E Remote Control - Toshiba CX27F60 Owner's Manual

Programming the Remote Control
• This Remote Control is preprogrammed to operate TOSHIBA VCRs.
• To use VCRs other than TOSHIBA models (or Cable converter), perform the following procedures before operating.
LOCATE
SWAP
SOUaCE
REC PAUSS'SI3U. S L TVIVCR
-4
0
U)
m
W
--- POWER
RECALL
Number
buttons
For future reference, write the code
you used.
VCR CODE:
CABLE CODE:
1
Refer to the "VCR code table" (or "Cable TV convetl"er code table'3
on pages 14 and 15 to find the code number that corresponds to the
brand name of your VCR (or your converter).
If more than one number is listed, try each one separately until you
find the one that works.
2 Set the TV/CABLE/VCR switch to "VCR" (or "CABLE").
3
Hold down RECALL while pressing the Number buttons for the three
digit code number for your brand of VCR (or conver:er).
The transmit indicator lights up for 1 second when the programming
is completed.
4
When an operation error has occurred, the indicato; blinks.
Press RECALL again to reset.
Point the Remote Control at the VCR (or at the converter) and press
POWER to test the code number.
- If the right number was entered, the VCR (or the converter) should
turn on.
- If the VCR (or the converter) does not respond to the Remote
Control, repeat steps 1 to 4 with another c'ode number.
Notes:
• You have to reprogram the Remote Control when you change its
batteries.
• Some newer VCR's are capable of working on either of two remote
codes. These VCR's have a switch labeled "VCR1/VCI_2".
If your VCR has this kind of switch, and does not respond to any of the
code numbers for your VCR brand name, set the switch to another
position ("VCRI" or "VCR2") and reprogram the Remote Control.
o
0
O_
E
t_
t-
O')
E
01
o
tt
t_
>
o
>
p-
0
>
Q}
E
€-
.g
13