Programming The Remote Control - Toshiba CF32H40 Owner's Manual

programming the Remote Control
• This Remote Control is preprogrammed to operate TOSHIBA VCR's.
• To use VCR's other than Toshiba models (or cable converter), perform the following procedures before operating.
FAV CH TVNIDEC
SLOW PAUSE R_ FF
TOSHIBA
RECALL
Number
For future reference, write the code
you used. ..
VCR CODE:
CABLE CODE:
1
Refer to the "VCR code table" (or "Cable TV converter code table')
on pages 12 and 13 to find the code' number that corresponds to the
brand name of your VCR (or converter).
If more than one number is listed, try each one separately until you
find the one that works.
2
Set the TV/CABLE/VCR switch to "VCR" (or "CABLE").
3
4
Hold down RECALL while pressing the Number buttons for the three
digit code number for your brand of VCR (or converter).
Point the Remote Control at the VCR (or at the converter) and press
POWER to test the code number.
-If the right number was entered, the VCR (or the converter) should
turn off.
-If the VCR (or the converter} does not respond to the Remote
Control, repeat steps 1 to 4 with another code number.
Notes:
• You have to reprogram the Remote Control when you change its
batteries.
• Some newer VCR's are capable of working on either of two remote
codes. These VCR's have a switch labeled "VCR1NCR2".
If your VCR has this kind of switch, and does not respond to all the
code numbers for your VCR brand name, set the switch to another
position ("VCR1" or "VCR2") and reprogram the Remote Control.
m
o
o
4)
o
E
4)
c¢
4)
.E
E
E
8
P
4)
4)
>
c
o_
>
o
E
®
€-
"3
1t