Programming The Remote Control For Use With A Cable Tv Converter/Satellite Receiver, Vcr Or Dvd Player - Toshiba FSTPURE 26HF84 Owner's Manual

÷
To controm a DVD pmayer:
Program the remote
controI to recognize the
brand of your DVD
player (see
"Programming the
remote control for use
with a cable TV
converter/sateIIite
receiver, VCR or DVD
player" below). The
Power
Input (TV)
Display
Number
buttons
TOP Menu --
Pic Size (TV) --
DVD MENU --
buttons shown at right ENTER --
TV • CBL/SAT, VCR
wil! then control the o DVD selector
DVD player. Volume AT (TV)--
Set the TV • CBL/SAT, DVD Clear --
VCR * DVD selector to Mute (TV)
DVD controls --
"DVD" first.
DVD Skip/Search _ / 1<4 --
Light --
÷
Programming the remote control for use with
a cable TV converter/satellite receiver, VCR or
DVD player
This remote control is pre-programmed to operate Toshiba satellite
receivers, VCRs and DVD players. To control cable TV converters/
satellite receivers, VCRs and DVD players other than Toshiba models,
you must follow the steps below to program your remote control.
1. Refer to the code tables (on pages 18 and 19) to find the
corresponding code for your brand.
If more than one code is listed, try each one separately until you
find the one that works.
2. If you are programming the remote control to operate your:
• Cable TV converter/satellite receiver: Set theTV • CBL/
SAT • VCR • DVD selector to "CBL/SAT."
• VCR: Set the TV. CBL/SAT • VCR. DVD selector to "VCR/'
• DVD piayer: Set the TV. CBL/SAT _VCR. DVD selector to "DVD/'
3. While hoiding down RECALL, press the Channei Number buttons
to enter the three-digit code for your cable TV converter/satellite
receiver, VCR or DVD player brand.
4. Point the remote control at the cable TV converter/sateflite
receiver, VCR or DVD player, and press POWER to test the code.
• If the cable TV converter/satellite receiver, VCR or DVD player
responds, you entered the correct code.
• If the cable TV converter/satellite receiver, VCR or DVD player
does not respond, repeat steps 1-4 using another code.
5. Set the TV. CBL/SAT - VCR. DVD seIector to "TV" to control the TV.
For future reference, write down the codes you used:
Cabie TV converter/satellite receiver code
VCR code
DVD player code
17
-- Recall
-- Channel
Numbers
TV * CBL/SAT
• VCR • DVD selector
Notes:
, When shipped from the factory, the remote
control is set to operate your T_X
. Ifyou do not enter the code within 10
seconds from step 1 or if you enter a code
not listed below, this operation is canceled.
. Each time you replace the batteries, you
must reprogram the remote control.
. Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch/abeted "VCR 1/VCR2."
If your VCR has this kind of switch and does
not respond to any of the codes for your
VCR, set the switch to the other position
(VCR1 or VCR2) and reprogram the remote
control.
÷
3R40121A/E P16-23
÷
6/7/04, 18:57