Table of Contents
Advertisement
÷
To control a DVD player:
Program the remote
control to recognize the
brand of your DVD
player (see
"Programming the
remote control to
operate your other
devices" below.) The
buttons shown at right
wiil then control the
DVD player.
Press "DVD" firsL
Input (TV)
Recall
Mute (TV)
Number
Volume +/- (TV)
DVD
Pic Size (TV)
DVD MENU
AT
_
ENTER
DVD controls
DVD Skip/Search
TOP Menu
DVD
÷
Programming
the remote
control
to operate
your other devices
This remote control is pre-programmed
to operate Toshiba satellite
receivers, VCRs and DVD players. To controI cable TV converters/
satellite receivers, VCRs and DVD piayers other than Toshiba models,
you must follow the steps below to program your remote control.
1.
Refer to the code tables (on pages 18 and 19) to find the
corresponding
code for your brand.
If more than one code is listed, trY each one separately until you
find the one that works.
2.
If you are programming
the remote control to operate your:
,, Cable TV convertedsatellite
receiver: Press "CBL/SAT."
,, VCR: Press "VCR."
,, DVD player: Press "DVD."
3.
While holding down RECALL, press the Channel Number buttons
to enter the three-digit code for your cable TV converter/satellite
receiver, VCR or DVD player brand.
4.
Point the remote control at the cable TV converter/satellite
receiver, VCR or DVD player, and press POWER to test the code.
,, If the cable TV converter/satellite
receiver, VCR or DVD player
responds, you entered the correct code.
,, If the cabie TV converter/satellite
receiver, VCR or DVD player
does not respond, repeat steps 1-4 using another code.
5.
Press "TV" to control the TV.
For future reference, write down the codes you used:
Cable TV converter/satellite
receiver code
VCR code
DVD player code
17
Notes:
Recall
Channel
Numbers
DVD
CBL/SAT
When shipped from the factory, the remote
control is set to operate your T_Z
If you do not enter the code within 10
seconds from step 1 or if you enter a code
not listed befow; this operation is canceled.
Each time you replace the battedes, you
must reprogram the ,remote control.
Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled "VCR1/VCR2."
ff your VCR has this kind of switch and does
not respond to any of the codes for your
VCR, set the switch to the other position
(VCR1 or VCR2) and reprogram the remote
control.
÷
J3U00121A(E)
P16-23
17
_
10/03/2005,
6:20 AM
Advertisement
Table of Contents
