Sony SLV-N81 Operating Instructions Manual page 11

[] Use this hookup if your TV has the Control S function (SLV-N81 only)
VCR Stereo receiver
Tv
I_ ^u× IN
_Audio/video cable
i (not supplied)
i Audio cable (not supplied)
Control S cable (not supplied)
I
Notes
• To play a tape in stereo, you must use the A/V connection.
• Use the RK=G69 (ontrol S cable (not supplied) lbr Control S connections.
Completing A/V hookup:
After you've connected your TV and completed antenna or cable hookup, return to
this procedure to complete VCR set up. This will prevent unwanted noise in the RF
channel.
Press MENU and select
ADVANCED OPTIONS.
SET......
QUIT
Set AUTO ANT SELECT
to OFF and press OK.
,UTO A_T SELECT
AUTO _TE_EO
TUNERAUDIO
TaPE_E_ECT
AUTOTaPE_EO
NE×T
_UlT
For details, see page 92.
Caution
Connections between the VCR's VHFiUHF connector and the antenna terminals of the TV
receiver should be made only as shown in the tbIIowing instructions. Failure to do so may result
in operation that violates the regulations of the Federal Communications Commission regarding
the use and operation of RF devices. Never connect the output of the V(R to an an*enna or
make simultaneous (parallel) antenna and VCR connections at the antenna terminals of your
receiver.
Note to CATV system installer (in USA)
"lhis reminder is provided to call tbe CATV system installer_s attention to Article 820- 40 oftbe
NEC tbat provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the groundiz_g system of the building, as close to the point of cable
entry as practical.
Hookups
I 11