Advertisement
back-pressure
channel-group
description
dot1x max-req
dot1x multiple-hosts
dot1x port-control
dot1x re-authentication
dot1x single-host-violation
dot1x timeout quiet-period
dot1x timeout re-authperiod
dot1x timeout server-timeout
dot1x timeout supp-timeout
dot1x timeout tx-period
duplex
flowcontrol
garp timer
gvrp enable (interface)
gvrp registration-forbid
gvrp vlan-creation-forbid
ip address
ip address dhcp
lacp port-priority
lacp timeout
Enables Back Pressure on a given interface.
Associates a port with a Port-channel.
Adds a description to an interface.
Sets the maximum number of times that the Ethernet Switch Module
sends an EAP - request/identity frame to the client, before restarting the
authentication process.
Allows multiple hosts (clients) on an 802.1X-authorized port, that has
the dot1x port-control Interface Configuration mode command set to
auto.
Enables manual control of the authorization state of the port.
Enables periodic re-authentication of the client.
Configures the action to be taken, when a station whose MAC address is
not the supplicant MAC address, attempts to access the interface.
Sets the number of seconds that the Ethernet Switch Module remains in
the quiet state following a failed authentication exchange.
Sets the number of seconds between re-authentication attempts.
Sets the time for the retransmission of packets to the authentication
server.
Sets the time for the retransmission of an EAP-request frame to the
client.
Sets the number of seconds that the Ethernet Switch Module waits for
a response to an Extensible Authentication Protocol (EAP) -
request/identity frame, from the client, before resending the request.
Configures the full/half duplex operation of a given ethernet interface
when not using auto-negotiation.
Configures the Flow Control on a given interface.
Adjusts the GARP application join, leave, and leaveall GARP timer
values.
Enables GVRP on an interface.
De-registers all VLANs, and prevents dynamic VLAN registration on the
port.
Enables or disables dynamic VLAN creation.
Sets an IP address.
Acquires an IP address on an interface from the DHCP server.
Configures the priority value for physical ports.
Assigns an administrative LACP timeout.
29
Command Modes
Advertisement
