Advertisement
Syntax
snmp-server host {ip-address | hostname} community-string [traps | informs] [1 | 2] [udp-port
port] [filter filtername] [timeout seconds] [retries retries]
no snmp-server host {ip-address | hostname} [traps | informs]
•
ip-address — Internet address of the host (the targeted recipient). An out-of-band IP
address can be specified as described in the usage guidelines.
•
hostname — Hostname of the host. (Range: 1 - 158 characters).
•
community-string — Password-like community string sent with the notification operation.
(Range: 1 - 20 chars)
•
traps — Sends SNMP traps to this host (Default).
•
informs— Sends SNMP informs to this host. Not applicable to SNMPv1.
•
1— SNMPv1 traps will be used.
2— SNMPv2 traps will be used (Default).
•
•
udp-port port — UDP port of the host to use. The default is 162. (Range: 1 - 65535)
•
filter filtername — A string that is the name of the filter that defines the filter for this
host. If unspecified, does not filter anything. (Range: Up to 30 characters).
•
timeout seconds — Number of seconds to wait for an acknowledgment before resending
informs. The default is 15 seconds. (Range: 1 - 300)
retries retries — Maximum number of times to resend an inform request, when response
•
is not received for generated message. The default is 3. (Range: 0 - 255)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
•
When configuring snmp v1 or v2 notification recipients, the software should automatically
generate notification views for those recipients, for all MIBs.
•
To define an SNMP recipient on the out-of-band port, use the out-of-band IP address format:
oob/ip-address.
Example
The following example enables SNMP traps for host 10.1.1.1 with community string
"management" using SNMPv2.
Console (config)# snmp-server host 10.1.1.1 management 2
225
SNMP Commands
Advertisement
