Programming The Remote; Vcr - ProScan PS27115FE1BC User Manual

PROGRAMMING THE REMOTE
The universal remote can be programmed to control most brands of
remote controllable VCRs and cable boxes. The remote is already
programmed to control most RCA, GE and ProScan TVs VCRa, DVD
players, laserdisc players and satellite receivers. Other manufacturers'
brands need to be programmed.
PROGRAMMING THE REMOTE TO CONTROL
A VCR
To determine whether the universal remote needs to be programmed,
turn the VCR on, point the remote at the VCR, and press the VCR1
button. Then press POWER or CH /' (channel up) or CH v (channel
down) to see if the VCR responds to the remote commands. If not, the
remote needs to be programmed.
Follow these steps to program your universal remote to control your
VCR:
1. ]-urn on the VCR to be programmed.
2. Look up your VCR brand and code number(s) on the code list on
the next page.
3. Press and hold the VCR1 button on the remote.
4,
5.
6,
Enter the two-digit code from the code list.
Release VCR1 then press POWER to see if the VCR responds to
the remote commands. If it doesn't, try pressing VCR1 and
POWER to see if the VCR responds.
Repeat these steps using the next code listed for your brand, until
the VCR responds to the remote commands.
of the brands that are s_own. Use the
codes shown at right or o_ the sheet
packed in with }'our remote.
[b progr am the DVD, VCR2 button to
coltrol a secold VCR, follow these steps
but use the [)\/D_VCR2 butto_ instead of
the VCRI buttoL
26