ProScan PS27115FE1BC User Manual page 59

THINGS TO DO
BEFORE
CONNECTING
COMPONENTS
Protect your components from power surges
Connect all components before plugging any power
cords into the wall outlet.
Always turn off the TM and/or component before you
connect or disconnect any cables,
POSITION CABLES CORRECTLY TO AVOID
AUDIO HUM OR INTERFERENCE
Insert all cable plugs firmly into their jacks.
Place the audio/video cables to the sides of theTV's
back panel instead of straight down the middle after
you connect your components.
Try not to coil any twin-lead cables and keep them
away from the audio/video cables as much as possible.
Make sure all antennas and cables are properly
grounded. Refer to the SafetyTips sheet packed with
your TV.
PROTECT YOUR COMPONENTS FROM
OVERHEATING
Do not block ventilation holes in any of the
components, Arrange the components so that air can
circulate freely.
Do not stack components.
Allow adequate ventilation when placing your
components in a stand,
Place an amplifier on the top shelf of the stand so
heated air rising from it will not flow around other
components.