Programming The'remote; To Control A Vcr - ProScan PS27125 User Manual

PROGRAMMING THE REMOTE
The universal remote can be programmed to control most brands of
remote controllable VCRs and cable boxes. The remote is already
programmed to control most ProScan, RCA, and GE TVs VCRs, DVD
players, laserdisc players and satellite receivers. Other manufacturers'
brands need to be programmed.
PROGRAMMING THE REMOTE TO CONTROL
A VCR
To determine whether the universal remote needs to be programmed,
turn the VCR on, point the remote at the VCR, and press the VCR1
button. Then press POWER or CH ^ (channel up) or CH v (channel
down) to see if the VCR respondsto the remote commands. If not, the
remote needs to be programmed.
Follow these stepsto program your universal remote to control your
VCR:
1. Turn on the VCR to be programmed.
2. Look up your VCR brand and code number(s) on the code list on
the next page.
3. Press and hold the VCR1 button on the remote.
4,
5.
6.
Enter the two-digit code from the code list.
Release VCR1 then press POWER to see if the VCR responds to
the remote commands. If it doesn't, try pressing VCR1 and
POWER to see if the VCR responds.
Repeat these steps using the next code listed for your brand, until
the VCR responds to the remote commands.
You'll use these buttons when you
program the remote to control any
devices.
This remote may not operate all models
of the brands that are showm Use the
codes shown at right or on the sheet
packed in with your remote.
To program the DVDoVCR2 button to
control a second VCR, follow these steps
but use the DVD°VCR2 button instead of
the VCR1 button.
30