Netopia R9100 User Reference Manual page 93

Go to the System Configuration screen. Select IP Address Serving and press Return. The IP Address Serving
screen will appear.
Number of Client IP Addresses:
1st Client Address:
Client Default Gateway...
Serve DHCP Clients:
DHCP NetBios Options...
Serve BOOTP Clients:
Serve MacIP/KIP Clients:
MacIP/KIP Static Options...
Follow these steps to configure IP Address Serving:
If you enabled IP Address Serving, DHCP, BootP clients, Dynamic WAN clients, and MacIP/KIP clients (if you
have the AppleTalk kit installed) are automatically enabled.
Select Number of Client IP Addresses and enter the total number of contiguous IP addresses that the
Netopia R9100 will distribute to the client machines on your local area network. 12-user models are limited
to twelve IP addresses.
In the screen example shown above, five Client IP addresses have been allocated.
Select 1st Client Address and enter the first client IP address that you will allocate to your first client
machine. For instance, on your local area network you may want to first figure out what machines are going
to be allocated specific static IP addresses so that you can determine the pool of IP addresses that you will
be serving addresses from via DHCP, BootP, Dynamic WAN, and/or MacIP.
Example: Your ISP has given your Netopia R9100 the IP address 192.168.6.137, with a subnet mask of
255.255.255.248. The subnet mask allocated will give you six IP addresses to use when connecting to the
ISP over the Internet (for more information on IP addressing refer to
Addressing"). Your address range will be from .137-.143. In this example you would enter 192.168.6.138
as the 1st Client Address, since the router itself must have an IP address.
To enable DHCP, select Serve DHCP Clients and toggle it to Yes. DHCP serving is automatic when IP
Address Serving is enabled.
IP Setup and Network Address Translation 9-17
IP Address Serving
5
176.163.222.10
176.163.222.1
Yes
Yes
Yes
Appendix B, "Understanding IP