Table of Contents
Advertisement
8-2 User's Reference Guide
Address Translation Enabled:
Local WAN IP Address:
Filter Set...
Remove Filter Set
Receive RIP:
Aux Serial Port...
Data Rate (kbps)...
Aux Modem Init String:
Set up the basic IP attributes of your Ethernet Module in this screen.
Address Translation Enabled allows you to specify whether or not the router performs Network Address
Translation (NAT) on the Ethernet WAN port. NAT is enabled by default.
Local WAN IP Address allows you to manually configure an IP address for use on the Ethernet WAN port.
The value 0.0.0.0 indicates that the device will act as a DHCP client on the Ethernet WAN port and attempt
to acquire an address from a DHCP server. By default, the router acts as a DHCP client on the Ethernet
WAN port.
Local WAN IP Mask allows you to manually configure an IP subnet mask for use on the Ethernet WAN port.
This item is visible only if you have configured a non-zero Ethernet IP Address; otherwise, the router obtains
a subnet mask via DHCP.
The Filter Set pop-up allows you to associate an IP filter set with the Ethernet WAN port. See
and filter sets" on page
Remove Filter Set allows you to remove a previously associated filter set.
The Receive RIP pop-up controls the reception and transmission of Routing Information Protocol (RIP)
packets on the Ethernet WAN port. The default is Both. The Transmit RIP pop-up is hidden if NAT is
enabled.
Routing Information Protocol (RIP) is needed if there are IP routers on other segments of your Ethernet
network that the Netopia R9100 needs to recognize. Set to "Both" (the default) the Netopia R9100 will
accept information from either RIP v1 or v2 routers. Alternatively, select Receive RIP and select v1 or v2
from the popup menu. With Receive RIP set to "v1," the Netopia R9100's Ethernet port will accept routing
information provided by RIP packets from other routers that use the same subnet mask. Set to "v2," the
Netopia R9100 will accept routing information provided by RIP packets from other routers that use
different subnet masks.
WAN Ethernet Configuration
13-4.
Yes
0.0.0.0
Both
Async Modem
57.6
AT&F&C1&D2E0S0=1
"About filters
Advertisement
Table of Contents
