Helpful Hints And Tips - Zanussi ZWN 7140 AL User Manual

Important! The Delay Start cannot be
selected with the draining programme.
Altering an option or a running
programme
It is possible to change some options before the
programme carries them out.
Before you make any change, you must pause
the washing machine by pressing button 7.
Changing a running programme is possible only
by resetting it. Turn the programme selector dial
to and then to the new programme position.
Start the new programme by pressing button 7
again.
The washing water in the tub will be not emp-
tied out.
Interrupting a programme
Press the button 7 to interrupt a programme
which is running, the corresponding pilot light
starts blinking. Press the button again to restart
the programme.
Cancelling a programme
Turn the selector dial to
gramme which is running. Now you can select a
new programme.
Opening the door after the programme
has started
First set the machine to pause by pressing the
button 7.
If the pilot light 9 blinks and after a few minutes
goes off, the door can be opened.
If the pilot light 9 remains lit, this means that the
machine is already heating or that the water lev-
el is too high. In any case, do not try to force the
door open!
Stand by : once the programme has finished
after a few minutes the energy saving system
will be enabled. The brightness of the display is

Helpful hints and tips

Sorting out the laundry
Follow the wash code symbols on each garment
label and the manufacturer's washing instruc-
tions. Sort the laundry as follows: whites, col-
oureds, synthetics, delicates, woollens.
12
to cancel a pro-
If you cannot open the door but you need to
open it, you have to switch the machine off by
turning the selector dial to
nutes the door can be opened.
(Pay attention to the water level and tem-
perature!).
After closing the door, it is necessary to select
the programme and options again and to press
button 7.
At the end of the programme
The machine stops automatically. Some acous-
tic signals sound and a blinking
the display. The pilot light of button 7 and the
pilot light 9 go off.
If you have set a programme or an option that
ends with water left in the tub, the pilot light 9
remains on. The door is locked to indicate that
the water must be emptied out. During this time
the drum continues to turn at regular intervals
until water draining.
Follow the below instructions to empty out the
water:
1. Turn the programme selector dial to
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by press-
ing the relevant button.
4. Press button 7.
At the end of the programme, the door is re-
leased and can be opened. Turn the programme
selector dial to to switch the machine off.
Remove the laundry from the drum and carefully
check that the drum is empty. If you do not in-
tend to carry out another wash, close the water
tap. Leave the door open to prevent the forma-
tion of mildew and unpleasant smells.
reduced. By pressing any button the appliance
will come out of the energy saving status.
Before loading the laundry
Never wash whites and coloureds together.
Whites may lose their «whiteness» in the wash.
. After a few mi-
appears on
.
www.zanussi.com