VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before beginning the installation and use of this appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
GENERAL SAFETY This appliance is for washing domestic-type, machine-washable • laundry only. This appliance is designed for single household domestic use • in an indoor environment. This appliance may be used in, offices, hotel guest rooms, bed • & breakfast guest rooms, farm guest houses and other similar accommodation where such use does not exceed (average) domestic usage levels.
SAFETY INSTRUCTIONS INSTALLATION • Make sure not to cause damage to the mains plug and to the mains cable. Should the mains The installation must comply with cable need to be replaced, this must be carried relevant national regulations. out by our Authorised Service Centre. •...
SERVICE are intended to withstand extreme physical conditions in household appliances, such as • To repair the appliance contact the Authorised temperature, vibration, humidity, or are intended Service Centre. Use original spare parts only. to signal information about the operational •...
Feet for levelling the appliance The info label reports the model name (A), product number (B ) and serial number (C). Inlet hose Drain hose Mains cable Transit bolts Hose support Rating plate Information for register product. The rating plate reports the model name (A) , product number (B), electrical ratings (C) and serial number (D).
UNPACKING DRAINAGE We recommend that you keep the packaging and the transit bolts for any transport of the appliance. Adjust the appliance correctly to prevent vibration, noise and movement of the appliance when it operates. WARNING! Do not put cardboard, wood or equivalent materials below the appliance feet to adjust the level.
Connect the appliance to an earthed socket. The power supply cable must be easily accessible after installing the appliance. For any electrical work required to install this appliance, contact our Authorised Service Centre. The manufacturer does not accept any responsibility for damage or injury through failure to comply with the above safety precaution.
DISPLAY A. The time area: • : the programme duration • : the "finish in" time • : the alarm codes • : the message of error • : the programme is completed. B. The child lock indicator: • The indicator comes on when you activate this device.
Page 10
Programme Maximum load Programme description Default temperature Reference spin (Type of load and level of soiling) Temperature range speed Refrescar 1 kg A very short cycle for lightly soiled cotton and syn- 30 °C 1200 rpm thetic items or worn only once. 40°C - 30°C Mix 20°...
Page 12
The related indicator comes on. TERMINA EN/EM With this option you can set the number of hours in ACLARADO/ENXAG. which you would like your washing programme to be completed. With this option you can perform only a last rinse of a selected washing programme.
BEFORE FIRST USE 3. Put 2 litre of water in the detergent During installation or before first use compartment for washing phase. you may observe some water in the This activates the drain system. appliance. This is residual water left in 4.
Page 14
A tune sounds when the appliance is activated. You can cancel or change the set of the Termina en/em option before you SETTING A PROGRAMME touch the button . After touching 1. Touch the programme button and set the the button you can only cancel the programme: Termina en/em option.
OPENING THE LID • The lid lock indicator is on. The indicator of While a programme (or the ) operates, the button flashes. The lid stays locked. • You must drain the water to open the lid. appliance lid is locked. The indicator is on.
• Be careful with the curtains. Remove the hooks • Use only detergents and other treatments and put the curtains in a washing bag or specially made for washing machines. First, pillowcase. follow these generic rules: • Do not wash laundry without hems or with cuts. –...
• To use the correct quantity of detergent, refer to softener for washing machines. In areas where the the quantity suggested by the detergent water hardness is soft it is not necessary to use a producer and check the water hardness of your water softener.
LID SEAL - Clean the drum with special products for stainless steel. Add a small quantity detergent into empty Regularly examine the seal and remove all objects drum, in order to rinse out any left residues. from the inner part. Clean it when needed, using ammonia cream cleanser agent without scratching - Run a short cotton programme at high the seal surface.
• Do not clean the drain filter if the water in the appliance is hot. • Regularly check the drain pump filter and make sure that it is clean. • Make sure that the impeller of the pump can rotate. If it does not rotate, contact the Au- thorised Service Centre.
TROUBLESHOOTING WARNING! Refer to Safety chapters. ALARM CODES AND POSSIBLE FAILURES The appliance does not start or it stops during operation. First try to find a solution to the problem (refer to the tables). WARNING! Deactivate the appliance before carrying out any check. With some problems, the display shows an alarm code and the button may flash continuously: Problem...
Page 21
Problem Possible solution • Make sure that the mains plug is connected to the mains socket. • Make sure that the appliance lid and drum door are closed. • Make sure that there is no damaged fuse in the fuse box. The programme does •...
After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Authorised Service Centre. The necessary data for the service centre on the rating plate. CONSUMPTION VALUES INTRODUCTION See the web link www.theenergylabel.eu for detailed information about Energy Label. The QR code on the energy label supplied with the appliance provides a web link to the infor- mation related to the performance of the appliance in the EU EPREL database.
Power consumption in different modes Off (W) Stand-by (W) Delay start (W) 0.48 0.48 4.00 Time to Off/Standby mode is 15 minutes maximum. COMMON PROGRAMMES These values are indicative only. Programme Litres hh:mm °C Algod. 2.60 85.0 3:25 53.00 1200 90°C Algod.