Zanussi ZWN 7140 AL User Manual page 24

35°
Open the porthole and extract the inlet hose.
Connect the hose with the angled connection
to the machine. Do not place the inlet hose
downwards. Angle the hose to the left or right
depending on the position of your water tap.
Set the hose correctly by loosening the ring
nut.
• After positioning the inlet hose, be sure to
tighten the ring nuts again to prevent leaks.
• The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
24
45°
Connect the hose to
a tap with a 3/4"
thread.
Water-stop device
A
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in the
window «A». Should this occur, turn the water
tap off and refer to your Service Centre to re-
place the hose.
Water drainage
The end of the drain hose can be positioned in
three ways:
In this case, make sure the end cannot come
unhooked when the machine is emptying. This
could be done by tying it to the tap with a
piece of string or attaching it to the wall.
Hooked over the
edge of a sink us-
ing the plastic
hose guide.
www.zanussi.com