Pci/Pnp Setup - ECS 945GCT-M2 Manual

Wake-Up by PME (Enabled)
The system can be turned off with a software command. If you enable this item, the system
can automatically resume if there is an incoming call on the PCI Modem or PCI LAN card.
You must use an ATX power supply in order to use this feature. Use this item to do wake-up
action if inserting the PCI card.
Power On by Ring (Disabled)
The system can be turned off with a software command. If you enable this item, the system
can automatically resume if there is an incoming call on the Modem. You must use an ATX
power supply in order to use this feature.
USB KB Wakeup From S3 (Disabled)
This item allows you to enable/disable the USB device wakeup function from S3/S4 mode.
PS2 Keyboard Wakeup (Disabled)
This item enable or disable you to allow keyboard activity to awaken the system from power
saving mode.
PS2 Mouse Wakeup (Disabled)
This item enable or disable you to allow mouse activity to awaken the system from power
saving mode.
Resume on RTC Alarm (Disabled)
The system can be turned off with a software command. If you enable this item, the system
can automatically resume at a fixed time based on the system's RTC (realtime clock). Use
the items below this one to set the date and time of the wake-up alarm. You must use an ATX
power supply in order to use this feature.
Press <Esc> to return to the main menu setting page.
PCI / PnP Setup
This page sets up some parameters for devices installed on the PCI bus and those utilizing
the system plug and play capability.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Init Display First
Allocate IRQ to PCI VGA
: Move
F1:General Help
PCI / PnP Setup
PCI Express Card
Yes
Enter : Select +/-/: Value F10: Save and Exit
F9: Optimized Defaults
ESC: Exit
Using BIOS
Help Item
Select which graphics
controller to use as
the primary boot
device.
35