Pci/Pnp Setup - ECS 662/1066T-M2 Manual

34
Resume on LAN (Disabled)
This item allows users to enable or disable LAN activity to wake up the system from
power saving mode.
Wake-Up by PME (Enabled)
This item allows users to enable or disable PCI activity to wake up the system form a
power saving mode.
Power On by Ring (Disabled)
The system can be turned off with a software command. If you enable this item, the
system can automatically resume if there is an incoming call on the Modem/Ring, or
traffic on the network adapter. You must use an ATX power supply in order to use this
feature.
Resume on RTC Alarm (Disabled)
The system can be turned off with a software command. If you enable this item , the
system can automatically resume at a fixed time based on the system's RTC (realtime
clock). Use the items below this one to set the date and time of the wake-up alarm. You
must use an ATX power supply in order to use this feature.
Press <Esc> to return to the main menu page.

PCI/PnP Setup

These options configure how PnP (Plug and Play) and PCI expansion cards operate in
your system. Both the the ISA and PCI buses on the motherboard use system IRQs
(Interrup ReQuests) and DMAs (Direct Memory Access). You must set up the IRQ and
DMA assignments correctly through the PnP/PCI Configurations Setup utility for the
motherboard to work properly. Selecting PnP/PCI Configurations on the main program
screen displays this menu:
Init Display First
Allocate IRQ to PCI VGA
Init Display First (PCI)
Use this item to decide which device to be the initial display device.
Allocate IRQ to PCI VGA (Yes)
If this item is enabled, an IRQ will be assigned to the PCI VGA graphics system. You
set this value to No to free up an IRQ.
Press <Esc> to return to the main menu page.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
Power Management Setup
PCI
Yes
: Move Enter: Select +/-/: Value
F1: General Help F9: Optimized Defaults
Using BIOS
Item Help
Options
PCI
PCI Express Card
F10: Save Esc: Exit