Power Management Setup - ECS 945GCT-M2 Manual

34
Parallel Port Mode (ECP)
Use this item to select the parallel port mode. You can select Normal (Standard Parallel
Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or BPP (Bi-
Directional Parallel Port).
ECP Mode DMA Channel (DMA3)
Use this item to assign the DMA Channel under ECP Mode function.
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
Press <Esc> to return to the main menu setting page.

Power Management Setup

This page sets up some parameters for system power management operation.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
ACPI Suspend Type
Soft-off by PWR-BTTN
PWRON After PWR-Fail
Resume On LAN
Wake-Up by PME
Power On by Ring
USB KB Wakeup From S3
PS2 Keyboard Wakeup
PS2 Mouse Wakeup
Resume on RTC Alarm
ACPI Suspend Type (S3(STR))
Use this item to define how your system suspends. In the default, S3, the suspend mode is a
suspend to RAM, i.e, the system shuts down with the exception of a refresh current to the
system memory.
Soft-Off By PWR-BTTN (Delay 4 Sec)
Under ACPI (Advanced Configuration and Power management Interface) you can create a
software power down. In a software power down, the system can be resumed by Wake Up
Alarms. This item lets you install a software power down that is controlled by the power
button on your system. If the item is set to Instant-Off, then the power button causes a
software power down. If the item is set to Delay 4 Sec, then you have to hold the power
button down for four seconds to cause a software power down.
PWRON After PWR-Fail (Power Off)
This item enables your computer to automatically restart or return to its operating status.
Resume On LAN (Disabled)
This item allows users to enable or disable LAN activity to wake up the system from a power
saving mode.
Power Management Setup
S3 (STR)
Delay 4 Sec
Power Off
Disabled
Enabled
Disabled
Disabled
Disabled
Disabled
Disabled
: Move Enter : Select +/-/: Value
F1:General Help F9: Optimized Defaults
Using BIOS
Help Item
Select the ACPI
state used for
System Suspend.
F10: Save and Exit
ESC: Exit