Refer to the illustration below for proper installation:
1
Attach either cable end to the connector on the motherboard.
2
Attach the other cable end to the SATA hard drive.
3
Attach the SATA power cable to the SATA hard drive and connect the other
end to the power supply.
This motherboard does not support the "Hot-Plug" function.
Installing a Floppy Diskette Drive
FDD: Floppy Disk Connector
Connect the single end of the of the floppy connector to the onboard floppy connector
firstly, and then connect the remaining plugs on the other end to the floppy drives
correspondingly.
You must orient the cable connector so that the pin 1 (color) edge of the
cable corresponds to the pin 1 of the I/O port connector.
Installing the Motherboard
21