Installing Memory Modules - ECS 945GCT-M2 Manual

12

Installing Memory Modules

This motherboard accommodates two memory modules. It can support two 240-pin DDR2
667/533/400. The total memory capacity is 2 GB.
DDR2 SDRAM memory module table
You must install at least one module in any of the two slots. Each module can be installed
with 256 MB to 1 GB of memory; total memory capacity is 2 GB.
Do not remove any memory module from its antistatic packaging until you
are ready to install it on the motherboard. Handle the modules only by
their edges. Do not touch the components or metal parts. Always wear a
grounding strap when you handle the modules.
Installation Procedure
Refer to the following to install the memory modules.
1 This motherboard supports unbuffered DDR2 SDRAM .
2 Push the latches on each side of the DIMM slot down.
3 Align the memory module with the slot. The DIMM slots are keyed with notches
and the DIMMs are keyed with cutouts so that they can only be installed
correctly.
4 Check that the cutouts on the DIMM module edge connector match the notches
in the DIMM slot.
5 Install the DIMM module into the slot and press it firmly down until it seats
correctly. The slot latches are levered upwards and latch on to the edges of
the DIMM.
6 Install any remaining DIMM modules.
Memory module
DDR2 400
DDR2 533
DDR2 667
Installing the Motherboard
Memory Bus
200 MHz
266 MHz
333 MHz