Yamaha RX-V1700 Owner's Manual page 80

You can enjoy good quality sound with the initial factory
settings. Although you do not have to change the initial
factory settings, you can change some of the parameters to
better suit the input source or your listening room.
Note
You cannot change the sound field parameter values when
"MEMORY GUARD" in "OPTION MENU" is set to "ON" (see
page 98). If you want to change the sound field parameter vahles,
set "MEMORY GUARD" to "OFI _'''.
m2
4= =2,5
3=
U.S.A. model
1 Turn on the video monitor connected to this
unit.
2 Set the operation mode selector to AMP and
then press PARAMETER on the remote
control.
The following display is shown in the OSD.
Sound field program category
H:.= "r' _ L,
Sci fi
Cursor_ ÷ ( F'PO LOGIC ,
[/$F' LE:IEL . •. +ODE:
F*. IHIT.PL'/. • ! EI,/:
P. RIIIOH SIZE.. 1.0
6. !HIT. ILL'/, , !6n_
Sound field parameters Sound field parameter
values
Press one of the sound field program
selector buttons repeatedly to select the
desired sound field program you want to
adjust.
CLASSICAL LIVE/CLUBENTERTAIN MOVI:
STEREO
Press A / V to select the desired sound field
parameter and then <1 / D to change the
selected sound field parameter value.
• Press C:>to increase the value.
• Press <1 to decrease the value.
PRESET/_H
A E/CA_, ',
• For details about the function arid control range of each sound
field parameter, see page 77.
• When you set a sound field parameter to a value other than the
initial factory settings, an asterisk mark (*) appears by the
sound field parameter name in the OSD.
• Repeat steps 3 and 4 as necessary to change other sound field
program parameter settings.
• The available sound field parameters lor some of the sound field
programs may be displayed on more than one page in the OSD.
In this case, press _ / V to scroll through pages.
• If you press and hold <3 / i:> to change the sound field
parameter value, the initial 151ctoryseuings are shown
momentarily in the front panel display.
• Use the "PARAM. lNl" lieamre in "OPTION MENU" to
initialize the parameters of each somld field program within a
sound field program group (see page 99).
• To initialize the parameters of the selected som_d field program,
press V repeatedly to select "PARAM. lNlT" and then press i:>
repeatedly.
5 Press PARAMETER to turn off the sound field
parameter display.
76 En