Yamaha RX-V1700 Owner's Manual page 23

This unit has the HDMI IN 1, HDMI tN 2 and HDMI OUT,jacks %r digital audio and video signal input/output. Connect
the HDMI tN 1 or HDMI IN 2,iack of this unit to the HDMI output,jack of other HDMI components (such as a DVD
player). Connect the HDMI OUT,jack of this unit to the HDMI IN ,jack of other HDMI components (such as a TV and a
projector).
The video or audio signals input at the HDMI IN 1 or HDMI IN 2,jack of the selected input source are output at the
HDMI OUT ,jack of this unit.
You can check the potential problem about the HDMI connection {see page 42).
• HDMI compatibility with this unit • HDMI jack and cable plug
Audio signal Audio signal Compatible
HDMI
types formats
components
2ch Linear 2ch, 32-192 kHz, CD, DVD-Video,
PCM 16120124 bit DVD-Audio, etc.
Multi-cb 8ch, 32-192 kHz, DVD-Audio, etc.
Linear PCM 16120124 hit
DSD 215. lcb, SACD, etc.
2.8224 MHz, I bit
Bitstream Dolby Digital, DVD-Video, etc.
DTS
This unit's HDMI interface is based on the following
standards:
• HDMI Version 1.2a (High-Definition Multimedia
interface Specification Version 1.2a) licensed by
HDMI Licensing, LLC.
• HDCP Revision 1.1 (High-bandwidth Digital
Content Protection System Revision 1.1) licensed
by Digital Content Protection, LLC.
• When CPPM copy-protected DVD audio is played back, video
and audio signals may not be output depending on the type of
the DVD player.
• This unit is not compatible with HDCP-incompatible HDMI or
DVI components.
HDM]
HDMI cable plug
• Wc recommend using an HDMI cable shorter than 5 meters (16
l_et) with the HDMI logo printed on it.
• Use a conversion cable (HDMI jack <_. DVI-D jack) to connect
this unit to other DVI components.
• Do not disconnect or connect the cable or turn off the power of
the HDMI components connected to the HDMI OUT jack of
this unit while data is being transferred. Doing so may disrupt
playback or cause noise.
• Audio signals input at input jacks other than the HDMI IN 1 or
HDMI IN 2 of this unit cannot be digitally output at the
HDMI OUT jack.
• If you turn off tbe power of the video monitor connected to the
HDMI OUT jack via a DVI connection, this unit may l_dl to
establish the connection to the component.
• The analog video signals input at the composite video, S-video
and component video jacks can be digitally up-converted to be
output at the HDMI OUT jack. Set "V CONV." to "ON" in
"MANUAL SETUP" (see page 98) to activate this feature.
19 En