Yamaha RX-V1700 Owner's Manual page 110

Press and hold the button you want to
program on the other remote control until
"OK" appears in the display window on the
remote control.
"NG" appears in the display window on the remote
control if learning was unsuccessful. In this case, start
over h'om step 4.
(U.S.A. model)
O000(S
00000
\ 00Q
Other remote control
• II you want to pmgrgun another lunction, repeat steps 4
and 5.
• II you continuously want to progran_ another l[lnction lor
another component, press SELECT A / V to select the
component, and then repeat steps 4 and 5.
Press LEARN again to exit the learning
mode.
You can change the name of the input source that appears
in the display window on the remote control ii"you want to
use a different name than the factory preset. This feature is
useful when you have set an input area to control a
different component.
Set the operation mode selector to AMP or
SOURCE and then press an input selector
button or .:_to select the input area you want
to rename.
The name of the selected input area appears in the
display window.
O
TV pllONO TUNER P_ M[ILTI CI_IN
©
©
or C) C) C)
V_AUX/DOCK CBUSAT _JID4TAPE CD_R
_) VCR 10VP,!VCR 2
C) C)
(U.S.A. model)
i;;= = i:'_/
I_ I!' |g
• "ERROR" appears in the display window on the remote control
if you press a button not indicated in the respective step, or
when yo[t press more than one button simultaneously.
• This remote control can learn approximately 200 flmctions.
However, depending on the signals learned, "FULL" may
appear in the display belore you program 200 functions. In this
case, clear unnecessary programmed functions to make room
lot further learning.
• Learning may not be possible in the lollowing cases:
when the batteries in the remote control for this m_it or other
components arc weak.
- when the distance between the two remote controls is too
great or too small.
- when the remote control infrared windows are not facing each
other at the appropriate angle.
when the remote control is exposed to direct sm_light.
-when the function to be programmed is continuous or
[tncol ItIIlon.
Press RENAME using a ballpoint pen or
similar object.
11you do not complete each ol the lollowing steps within 30
seconds, the renaming mode will be automatically canceled.
In this case, start oxer lrom 2.
106 En