Yamaha RX-V1700 Owner's Manual page 13

_ol;ll:_oll_'-lK4;l_lI._#l;[_ifo]|v_,
Installing batteries in the remote control
_-_ _-_
Press the v part and slide the battery
compartment cover off.
Insert the four supplied batteries
(AAA, R03, UM-4) according to the polarity
markings (+ and -) on the inside of the
battery compartment.
3
Slide the cover back until it snaps into place.
• Installing batteries in the Zone 2/Zone 3
remote control (Except Europe model)
• Change all of the batteries if you notice the following
conditions:
- the operation range of the remote control decreases.
the TRANSMlT indicator does not flash or its light becomes
dim.
• Do not use old batteries together with new ones.
• Do not use different types of batteries (such as alkaline and
manganese batteries) together. Read the packaging carefully as
these dill'crcnt types of batteries may have the same shape and
color.
• If the batteries have leaked, dispose of them immediately. Avoid
touching the leaked material or letting it come into contact with
clothing, etc. Clean the battery compamnent thoroughly before
installing new batteries.
• Do not throw away batteries with general house waste: dispose
of them correctly in accordance with your local regulations.
• If the remote control is without batteries lot more than 2
minutes, or if exhausted batteries remain in the remote control,
the contents of the memory may be cleared. When the memory
is cleared, insert new batteries, set up the remote control code
and program any acquired functions that may have been
cleared.
• Using the remote control
The remote control transmits a directional infrared ray.
Be sure to aim the remote control directly at the remote
control sensor on this unit during operation.
Remote control sensor
Approximately 6 m (20 ft)
1
2
Take off the battery compartment cover.
Insert the two supplied batteries (AAA, R03,
UM-4) according to the polarity markings
(+ and -) on the inside of the battery
compartment.
Snap the battery compartment cover back
into place.
• Do not spill water or other liquids on the remote control.
• Do not drop the remote control.
• Do not leave or slore the remote control in the lollowing types
of conditions:
places of high humidity, such as near a bath
- places of high temperaulres, such as near a heater or stove
- places of extremely low temperatures
dusty places
9En