Yamaha RX-V1700 Owner's Manual page 114

II:/:l/_[e) t:EKel;it:relll_:L, ttll:l_€
YOUcan clear all changes made in each flmction set, such
as learned functions, macros, renamed input area names
and setup remote control ID.
• Clearing function sets
Set the operation mode selector to AMP or
SOURCE and then press CLEAR by using a
ballpoint pen or similar object.
"CLEAR" appears in the display window.
SOUmE
&
or
i;;; i_= = ==;;.=
11you do not complete each ol the lollowing steps within 30
seconds, the clearing mode will be aulo.qlatically canceled.
In this case, start o\er lroHt step 1.
2 Press A / _ to select the clear mode.
L:CD (etc.) (L: Name of an input area)
Clears all learned functions in the respective
input re'ca. The name of a component is shown
after a semicolon _ ). Press an input selector
button to select the input area.
LAMP Clears all learned l_mctions for conlrolling the
amplifier functions of this refit.
L;ALL Clears all learned functions.
M;ALL Clears all programmed macros.
RNAME Clears all renamed source names.
FCTRY Clears all remote functions and returns the
remote R) the factory settings.
Press and hold CLEAR again for about 3
seconds.
"WAIT" appears in the display window. If"clearing
was successful, "C;OK" appears in the display
window on the remote control.
ii'= = "D_ |; |:
i J {
! IJ
Once you ha,,e cleared a learned function for a button, the
button reverts to the factory setting (or to the manulhcmrer
setting, if you have set remote control codes).
• "L;ALL" and "FCTRY" may take about 30 seconds to
complete.
• "C:NG" appears in the display window if clearing was
unsuccessfuh In this case start over from step 2.
• "ERROR" appears in the display window if you press a
button not indicated in the respective step, or if you press
more than one button simultaneously.
110 E,