Schwinn SR23 Assembly Manual page 16

Step 9 Install Seat Assembly
Parts:
• Seat Assembly (From Steps 3 through 7)
• Seat Rail (Ref. H)
• Seat Rail Bracket (Ref. D-22)
Tools:
• Supplied Allen Wrench
NOTE: To ease assembly, use two people for this step.
9-1 Pull out on the Seat Adjustment Knob (K-3) while sliding the
Seat Assembly onto the Seat Rail (H). Release the Adjustment Knob to
lock the Seat Assembly in place.
NOTE: Make sure the seat Adjustment Knob is on the side of the
Seat Rail that has the holes.
9-2 Reinstall the Seat Rail Bracket to the Seat Rail making sure the Tab of the
Bracket faces forward.
9-3 Reconnect the Heart Rate Wires and reinstall the Seat Rail with
Seat Assembly on the main unit. (Figure A)
NOTE: After reconnecting the Heart Rate Wires, tuck them into
the hole in the frame to avoid pinching the wires.
9-4 Connect the Heart Rate Wire (M) to the jack on the junction box labeled
"HAND PULSE". (Figure B)
NOTE: To access the Junction Box you may have to loosen the knob
on the Seat Back, raise it upward then re-tighten the knob.
This also how you adjust the Seat Back to position
the lumbar support to your preference.
FigureB
FigureA
H
M
D-22
\
K-3
15