Table of Contents
Advertisement
C@nnecti@ns
Setup
Why You Should Connect This G-LINK Cable
The G-LINK cable enables the GUIDE Plus+ system (the on-screen
interactive program
guide)
to
wnrl,: with your VCR and/or cable box,
Cable Box-
If your TV is connected
to a cable box you nltlSt connect the G-LINK cable to
receive TV program listings tk)r your area and to tune directly to a channel when the program
guide is on your TV screen.
VCR-- If your TV is connected
to a VCR and you don't connect the G-LINK cable, nne-tnuch
VCR
recording
won't work. The other l_,atures nl the guide will work properly.
G_LINK wands
How to Find the Remote
Sensor
YOUhave lo place the G-LINK wands in front of the remote sensor on the VCR and/or
cable box.
Some cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor
isn't labeled on your VCR and/or cable box, you need to use the remote cnntrnl that came with
the VCR and/or
cable box to locate the sensor.
1.
Turn off the VCR and/or cable bnx.
2.
Hold the remote control (not the one that came with your TV, but the one that came with
the cable box and/or VCt{ to which you're attaching the G-LINK cable) so that it is touching
the front of the component.
3.
Slowly move the remote control across the trnnt nt the component
(VCR or cable box) while
you press the power button on and off, YOu nmst press and release the power button each
time you move the remote (holding
down the button won't work).
/i.
II
II
,__
g-g-2
When the component
turns on, you've located the remote sensor.
If you don't have both a
cable box and a VCR
connected
to your TV,
just coil the cable of the
extra G-LINK wand with
a twist tie and leave it
behind the TV
Placing the G-LINK Wands
Place the G-LINK wands in f_ont of the remote s_,nsnr on your VCR and/or
cable box
approximately
one inch away []coin the remote sensor (see instructions
below).
TV (bagk panel)
@
_Connect
_
to G-tlftK jack
y_,__
__°nthe
back
of the TV,
v_¢
I_
14
Chapter1
Advertisement
Table of Contents
