Table of Contents
Advertisement
Jnf@r ati@n
Program
information
doesn't
download
Review your setup inf_)rmation and make sure its correct. Press MENU on the remote and sch, ct G'Ull)t_'t_hts+ _etlqz Go to page 17
for detaih'd
insn-uctions about the GUII)E Plus+ Setup menus.
The TV l_aust bc off to download
inf_rmation.
Lcaw, your TV off overnight
for at h'ast 10 hours to receive the initial download
for
your area.
If' you're using a cable box, leave it on so you can receive program
inf_rmation.
Scheduled
Watch
or Record doesn't
occur
Check Schcduh" for timer conflicts. Go to page 34 f_)r instructkms.
Make sure the wands of the G LINK cable are placed in front of the remote sensor(s)
on the component(s).
Make sure your VCR is turned off during the til_ae you've scheduled
to record a program
because the system turns the VCR on when
it starts recording
(if it's already on when recording
starts, the system will turn it off).
Make sure there is a tape in the VCR and that the VCR is connected
properly.
Be sure that you set up the VCR in the G_71)E t'hts+ _etup menus
If you don't complete
the (kn_/}iVuri*<g,fi_ra VCI¢steps
successfL_Ily, the Record option wont be available. Go to p. 20 f_r detailed
instructions.
If a cable box is attached to your TV make sure you set it up correctly
in the GUII)Et'lus+
,Setup menus. Go to page 18 19 R)r
detailed
instmctions.
The Remote
Control
Doesn't
Work
Something
might be between
the remote and the remote sensor on the component.
Make sure there is a clear path.
Maybe the remote isn't aimed directly at the component
(TV or VCR) that you're tly'ing to operate.
Maybe remo_
is not in TV Mode.
¸Press the TV button so remote will control T_
Maybe batteries in remote are weak, dead or installed incorrectly.
Put new batteries
in the remote. (Note, if you remove the
batteries,
you may have to reprogram
the remote to operate
other components.)
You might need to drain the remote's
microprocessor:
remove batteries and press the number
1 button for at Ieast 6() seconds.
Release the 1 button,
replace the batteries,
and (if necessary)
program
the remote again.
Problems
with
V-Chip/Parental
Controls
The rating
limits don't work
You must lock the settings. Go to the T/'MA//_:MI£%'_ (press MENU on your remote)
select Pare_ita/Controls
(press 6 on your
rel_aOte), select Lock t'a_mtal
Cbntrols (press 6 on your remote).
I don't
remember
my password
and I want
to unlock the TV
If' you forget your password,
simultaneously
press and hold MENI on the tch, vision and voltmae down on tlm remote f_)r 3 seconds.
Nothing appears
on the screen, Parental Controls simply unlock and you can re enter a password
via Lock Parental Controls.
The V=Chip won't
let me watch
a program
even though
it's not rated
as violent.
Maybe the movie was given an NR (Not Rated) status. After you block movie ratings, you must set NR to View separately
in order to
view movies with an Nh' rating.
56
Chapter S
Advertisement
Table of Contents
