Table of Contents
Advertisement
Using
Re @ e
C@n r@M
Using Direct Entry
].
TL_rn
on/he,
con_pont,
nt you
want
lilt'
r
enlnte
lo npeF,
t/__.
2.
Look tip file brand and code number(s) l_)r tile component on file code list on page 26.
3.
Press and hold file component button that cnr
remote to operate (VCR], DV]), elc.)
4.
En/er tile code 1} om tile code list.
5.
Release tile
conllm)nenl
bu//on,
6.
responds
to tile component
you want
tile
Press ON*OFF to see if tile component
r espnnds to tile r emote commands. I1it doesn'
t, try
pressing the component button and then ON*OFF again.
If you get no r esponse, repeat these steps using tile next code listed tk)ryour brand until tile
component r eslxmds to tile r emote conmlands.
The buttons
might
operate
differently
for
other components,
especially when you're
using another
component's
menu
system
How to Use the Remote After You've
Programmed
It
Once
tile remote
has been
programmed
successl\_lly,
you are ready
to use it to control
your
cnmpnnents.
To operale
tile component:
1.
Press
tile component
button
(TV, VCR1, VCR2, DVD, ALX, or SAT*CABLE)
lo set tile remote
to operate
tile component.
2.
Press
ON-OFF
to mrn tile component
ON or OFF.
3.
Use tile remote
bul/ons
thai apply
to that component.
Note:
{i'.},oz_ keep pressing
bJ_ttons and
tloll)irlg [gappetl._. the rel_ole
i._])l_Da!)[)' in ll)e
u rorlg mode,.
Yoz_ tnz_st press
the cotnponenl
bullotl
that matches
lhe componetll.you
want
to operate
(_.e., _/'.yoz_ want
to operate
lbe VCR, press" VCRI on hSe remote
contl_t
to
put
hSe remote
in VCR t_godP. )
27
Advertisement
Table of Contents
