Table of Contents
Advertisement
C@nnect @ns
Setup
Why You Should Connect This G-LINK Cable
The G-LINK cable enables the G{IDE Plus+ system (the on-screen
interactive program guide) to
work with your VCR and/or cable box.
Cable Box-
If your TV is connected
to a cable box you must connect tile G-LINK cable to
receive TV program listings lbr your area, and to tune directly to a channel when the program
guide is on your TV screen.
VCR-
If your TV is connected
to a VCR and ynH don't connect tile G-LINK cable, one-touch
recording
won't work. The other teatures nt the guide will work properly.
le
G_LINK wands
How to Find the Remote
Sensor
You have to place tile G-LINK wands in l_cnntof the remote sensor on the VCR and/or cable box.
Some cable boxes and VCRs have tile remote sensor labeled on tile unit. If the remolu sensor isn't
labeled on your VCR and/or cable box, you need to use the remote cnntrnl that came with the
VCR and/or cable box to locate the sensor.
1.
Turn off the VCR and/or cable box.
2.
Hold tile remote control (not the one that came with your TV, but tile one that came with tile
cable box and/or VCR to which you're attaching the G-LINK cable) so that it is touching
the
frnnt of the component.
3.
Slowly move tile remote cnntrnl across the front ol tile component
(\ CR or cable box) v_hile
you press the power button on and off. Ybu must press and release the power button each
time you move the remote (holding
down the button won't work).
4_
When tile component
turns on, you've located the remote sensor.
Tip
If you don't have both a
cable box and a VCR
connected
to your TV,
just coil the cable of the
extra G-LINK wand with a
twist tie and leave it
behind the T_
Placing the G-LINK Wands
Place the G-LINI<_ ",,_ a nds in front of tile remote sensor on your VCR and/or cable box
approximately
one inch away 11"()i11 the remote sensor (see instructions
below).
IV (ba_k panel)
12
Chapter
I
Advertisement
Table of Contents
