Table of Contents
Advertisement
Basic
11"!/ Operation
Changing
Channels
To change channels
by entering
nunlbers with the remote control, the
remote needs to be in the correct "mode": either DIRECTV mode (if you
subscribe
to DIRECTV ®programming)
or TV mode.
When
you
want
to watch
DIRECTV
®
programming,
put
the
remote
in DIRECTV
mode
1.
Make sure the "IV is in D1RECTV mode by pressing DIRECTV on the
remote control.
2.
Enter the channel number and press OK. If yon do not enter at least
three digits,
... wtll appear in the channel entry box, and the system
will wait for a valid entry.
When
you
want
to watch
a digital
or analog
TV channel,
put the
remote
in TV mode
If you want to watch a digital
channel:
1.
Make sure the TV is in TV mode by pressing TV on the remote control.
2.
Enter the primary channel number. This number will appear in the
primary channel entry box. If there is no subchannel,
press OK.
3.
If the primary channel number has fewer than three digits and you
want to enter subchannel
numbers, press the right arrow to advance to
tile subchannel
entry box.
4.
Enter the number of the subchannel.
This number will appear in the
snbchannel
entry box.
5.
Press OK on the remote control to tune to the channel.
If you want to watch an analog
channel:
1.
Make sure the TV is in TV mode by pressing TV on the remote contn)l.
2.
Enter the channel number. This number will appear in d_c primary
channel entry box. (Analog channels
don't have subchannels.)
3.
Press OK on the remote control to tune to the channel.
_
/RECTV
button
Channelentry
box
Highlighted
to
indicate
DIRECTV mode
TV
button
Sdsdlerr_
entry
Primar_
ox
channel
entry
box
Highlighted
to
indicate
TV
mode
Note that you can always
usethe channel up and
down buttons on the
remote control to change
channels within the
DIRECTVand TV modes•
Chapter
3
29
Advertisement
Table of Contents
