Step 3: Place Batteries In The Remote Control; Step 4: Plug In And Turn On The System; Step 5: Complete The Interactive Setup; Step 6: Order Programming - RCA Scenium HD65W20 User Manual

Thomson
Hide thumbs Also See for Scenium HD65W20:
Table of Contents

Advertisement

Setup
and
Connections
Step
3: Place
Batteries
in the Remote
Control
Follow these steps whenever
you need to install or change the batteries in your TV's
remote control.
I.
Remove the cover from the battery compartment.
2.
Insert batteries
into the battery compartment,
matching
the + and - end of each battery.
3.
Replace the cover.
Step 4: Plug
in and Turn on the System
Plug one end of the power cord into the back of the television as shown (m right.
Plug the other end into a wall outlet. Be sure to insert the plugs completely.
To turn on the TV, press the TV or ON-OFF
button on the remote control or the
POWER button on the front panel. It may take several seconds
for the TV to turn on.
Step
5: Complete
the
Interactive
Setup
Interactive
setup appears when you turn on your TV for the first time. Follow the
steps to configure
the basics of your system, such as setting up the time and clay,
searching
for available channels,
and setting up speakers.
To run it again, select
Assistance from the main menu, then select Interactive Setup. For more details, see
the section "Getting Assistance"
in this book.
Step 6: Order
Programming
You should decide if you would like to receive DIRECTV :"programming*.
To receive
DIRECTV ®programming,
your satellite dish antenna must be installed and pointed
correctly. You must also contact your service provider, DIRECTV.
Programming
with D1RECTV: Call 1-800 347-3288
• Receipt
of DIREC'I%' programming
is subject
to the terms
of the I)IItI'C'[ _, (Mstomcr
Aglccmc'_lt.
a
copy
is provided
at D[RECTVcom
and in your first bill¸ I)IREt"I*
¸' and the Qsclo
c )csign
logo aKu
m ,. emarks
( f I)IRECTV.
Inc.. a unit ol Hughes
El_clrlmics
Corp..
and are used
with permission
When you order
programming,
you need
to know your access card
number. To get the
number, select Assistance
from the main menu and
then select System Test.
Wait for the system to run
all of its tests. The access
card number
is displayed
at the end of the system
test.
Write
the access card
number
in the space
below
for easy reference:
18
Chapter1

Advertisement

Table of Contents
loading

Table of Contents