Table of Contents
Advertisement
Using
the
Remote
Using Direct Entry
1.
Turn on the component
to be programmed.
2.
Look up the brand and code number(s)
for the component
on the code list in the
section "Remote Control Codes" on the following page.
3.
Press and hold the remote control button you want to program.
4.
Enter the code from the code list.
5.
Release the button, and then press ON-OFF
to see if the component
responds
to the
remote control commands.
If it doesn't,
try pressing the component
button and then
ON-OFF
again.
6.
If you get no response,
repeat these steps using the next code listed for your brand
until the component
responds
to the remote control commands.
This remote control may
|
not operate all models of
J
the brands that are
shown. Use the codes
shown in this manual, or
on the sheet packed with
your remote control.
Using the Remote
to Control
a
Component
Once the remote has been programmed
successfully,
you are ready to use it to control
your components,
such as a VCR, DVD player, or laserdisc player.
To operate the component:
1.
Press the component
button (VCR1, VCR2, DVD, or AUX) to set the remote to control
the component.
2.
Press ON-OFF
to turn the component
on or off.
3.
Use the remote control buttons
that apply to that component.
r
Use the AUX button
to
control a separate
satellite receiver, if
necessary. Do not
reprogram
the DIRECTV
button.
Chapter
2
23
Advertisement
Table of Contents
