Table of Contents
Advertisement
Setup
and
Connections
Step
1: Unpack
the
System
Make sure to locate the remote control and power cord.
Step 2: Connect
Your TV to Other
Components
During the satellite dish antenna
installation,
the TV may have been connected
with
just a coaxial cable for the system test. Depending
on what components
you have,
another connection
may provide better picture and audio quality. The following
sections provide cable and connection
information
to help you decide what
connection
is best for you.
f:_
Remote
Control
Power Cord
Things
to Know
Before
Connecting
Components
Protect
Your
Components
from
Power
Surges
•
Connect all components
before plugging any power cords into the wall outlet.
•
Always turn off'the TV and other components
before you connec_ or disconnect
any cables.
Position
Cables
Correctly
to Avoid
Audio
Hum
or Interference
•
Insert all cable plugs firmly into their jacks.
Place the audio/video
cables to the sides of the TV's back panel instead of straight
down the middle after you connect your components.
•
Try not to coil any twin-lead cables; keep them away from the audio/video
cables
as much as possible.
•
Make sure all antennas
and cables are properly
grouncled. Refer to tire safety sheet
packed
with your unit.
Protect
Your
Components
from
Overheating
Do not block ventilation
holes in tiny of the components.
Arrange,
the components
so that air can circulate freely.
Do
not stack components.
•
Allow adequate
ventilation
when placing your components
in a sttlnd.
Place an amplifier on the top shelf of the stand s_ that healed air rising from it will
not l]ow :tiound other conrponents.
8
Chapter
1
Advertisement
Table of Contents
