Recording - Mitsubishi HS-U410 Owner's Manual

Chapter3: Operating YourVCR Recording: (cont.)
[_ Important:
_Important:
PROGRAM button again. If the VCR is stopped, it will turn
off and be ready to record your program at a later time. ]if the
VCR is playing, recording, fast forwarding or rewinding, the
menus will turn off, but the VCR power will remain on. You.
will have to turn the power OFF yoursel£
After the VCR power is turned OFF, be sure the programmed
recording light ({_) is lit on the fluorescent display. However,
if you have a cable box, leave the box turned ON, tuned to the
station you wish to record. If you are using an A/B switch,
remember to set the switch to the correct position.
If you press the QUICK PROGRAM button, but the clock is not
set, you will see the "Set the clock" menu.
The QUICK PROGRAM button does not work during One-Key
Programming.
Notes about programmedrecording
If you use the VCR when the programmed recol:ding light (El) i,;
lit, you may interfere with a programmed recording. If you want
to use the VCR before programmed recording begins, press the
POWER button on the remote once. This turns the programmed
recording light off and the VCR on. If you use the POWER battc,n
on the front panel for this purpose, you will have to press it twice.
Pressing it once turns off the programmed recordi::ag light; press-
ing it a second time turns the VCR on.
When you are finished using the VCR, turn the VCR power off
again, either with the POWER button on the remote or the
POWER button on the front panel. Make sure the programmed
recording light is back on.
After a program has been recorded, the VCR memory is cleared
(unless you have scheduled the VCR to record the program every
day or every week).
If there is already a program in the VCR's memory, you will see
the "Recap" screen when you bring up the menus for program-
ruing to record (unless you are programming with the QUICK
PROGRAM button). If the VCR's memory is full, you will have to
erase a program before you can enter a new one.
If a tape runs out during programmed recording, the VCR ejects
the tape and the programmed recording light. ([_) and the tape
status symbol ((ii iiil))will flash. Load a new tape and press the
REC button. The VCR will resume recording.
Do not overlap the recording times you program.
Set the time for recording to end a minute or two beyond the
program's scheduled broadcast time.
40