Table of Contents
Advertisement
Chapter 3: OperatingYourVCR
Setting UpYourVCRfor the FirstTime(cont.)
O
Turn the RF converter
OFF by following iastructions
on page
49.
Setting up your VCR if you are using a TV without Audio and Video
Inputs(OlderTV)
If you are using
an Older TV (A TV that does not have separate
Audio and Video inputs),
then your VCR wi[1 need to "convert"
the
VCR's picture
or menus
into a channel,
this channel
can be either
channel
3 or channel
4. The factory has already
selected
channel
3, however,
if channel
3 is a real channel
in your area, then you
will need to change
this to channel
4.
O
If you need to use channel
4, then before you turn on the
VCR, press the CHANNEL/N
button
and the ONE KEY
PROGRAM
button
on the front panel at the same time. The
words "Ant ch4" will be displayed
on the fcont panel and the
VCR will be reset to channel
4.
_Important:
Turn the VCR on by pressing
the POWEI_, button.
The VCR will return
to its initial
setting
(channel
3) if you press
the CHANNEL
V button
and the ONE KEY PROGRAM
button
on the front panel at the same time with the VCR turned
off. The
word "Ant ch3" will be displayed.
Usingthe RemoteControl
In this section, you'll learn how to set up and use your remote
control. This section includes:
• Using the remote control
to operate
the: VCR, and
• Using the remote control
to operate
the TV.
Using the remotecontrol to operatethe VCR
installing thebatteries
O
Unpack
two AAA size batteries.
To remove the back cover, press the ridged area gently,
then
push the cover in the direction
of the arrow and lift.
Load the batteries,
making
sure the polarities
(+) and (-) are
correct.
operating theremotecontrol
The HS-U130
has two VCR operation
modes: VCR-A mode and
VCR-B mode.
The HS-U130
is pre-set
to VCF,-A operation
mode.
O
Set the TV/VCR slide switch
on the remote
control
to VCR
position.
This "tells" the remote that you want to control
the
VCR.
18
Advertisement
Table of Contents
