Older Cable Box; Camcorder - Mitsubishi Electric DLP WD-52631 Owner's Manual

32 Chapter 2. TV Connections
Older Cable Box
Required: 3 coaxial cables, one two-way RF splitter.
These are not included with the TV.
When this setup is complete, you can use the TV remote
control, when programmed, to change channels on the
cable box.
Note: This connection is not recommended. The other
connections described in this chapter provide bet=
ter quality audio and video to the TV.
1. Connect the incoming cable to iN on the RF splitter.
2. Connect one coaxial cable from OUT on the RF split=
ter to ANT l/MAIN on the TV back panel.
3. Connect one coaxial cable from OUT on the RF split=
ter to IN on the standard cable box.
4. Connect one coaxial cable from OUT on the cable
box to ANT 2/AUX on the TV back panel.
Figure 15. Connecting an older cable box
Camcorder
Required: Analog stereo audio cables and either an S-
Video or composite video cable.
NOTE: For IEEE 1394 camcorders, see also chapter 7,
"Using IEEE 1394 Devices."
1. Connect either an S-Video or composite video cable
from VIDEO OUT on the camcorder to iNPUT
3/VIDEO or S=VIDEO on the TV. Connect only one
type of video cable; S-Video is recommended, if avail-
able.
2. Connect left (white) and right (red) audio cables from
AUDIO OUT on the camcorder to iNPUT 3/
AUDIO L and AUDIO R on the TV.
S-Video Cable
1.
omposite Video Cable
m
w
2. 2 1.
Figure 16. Analog connections for a camcorder