Wall Outlet Cable Or Cable Box - Mitsubishi Electric WS-55517 Owner's Manual

Connecting a Wall Outlet Cable or Cable Box
Wall Outlet Cable
Figure 1
It is very important to connect the incoming
cable for your primary viewing source to ANT-1,
especially for CableCARD™ use.
1. Connect the primary incoming coaxial lead cable to
ANT-1 MAIN on the TV back panel.
2. For an optional secondary antenna source, connect
an antenna (or cable) to ANT-2 AUX.
3. If you have subscribed to a CableCARD™ service,
the CableCARD can now be inserted into the
CableCARD SLOT. Using a phillips screwdriver,
remove the CableCARD cover screws. Insert the
CableCARD, then replace the cover and screws. If
you need more information regarding this service,
please contact your cable service provider.
Optional
Secondary
Antenna
or Cable
2.
E1394 E1394
T/ T T OUTPUT T/OUTPUT
TV back panel
(section detail)
Figure 1. Wall Outlet Cable
IMPORTANT
Additional connection cables are
not provided with the TV. They are
available at most electronic stores.
(can be used with a CableCARD™)
Primary
Wall Outlet
Cable
1.
ANT-2 ANT-1
AUX MAIN
DIGITA DIGITAL T T L
AUDIO AUDIO
CableCARD TM SLOT
– (DTV/CABLE /VHF/UHF) –
3. CableCARD TM SLOT
(cover removed)
Cable Box
(compatible with PIP/POP)
Figure 2
3 coaxial cables and one two-way RF splitter are required.
These are not included with the TV.
It is very important to connect the incoming
cable for your primary viewing source to ANT-1,
especially for CableCARD™ use.
1. Connect the incoming cable to IN on an RF splitter.
2. Connect one coaxial cable from OUT on the RF
splitter to ANT-1 MAIN on the TV back panel.
3. Connect one coaxial cable from OUT on the RF
splitter to IN on the cable box.
4. Connect one coaxial cable from OUT on the cable
box to ANT-2 AUX on the TV back panel.
4.
ANT-2
AUX
UT UT
(DTV/CABLE /VHF/UHF)
–
TV back panel (section detail)
2.
Incoming
Cable
1.
3.
Figure 2. Connecting a Cable Box
Note: NetCommand® will assume that your
Cable Box is connected as shown above. Also,
that Channel 3 is the default output channel for
the cable box. If either the connections or output
channel are different, use the Change option of
Edit NetCommand to apply the changes.
2.
ANT-1
MAIN
DIGITA DIGITAL T T L
AUDIO AUDIO
CableCARD SLOT CableCARD SLOT
–
4.
Cable Box
back panel section
3. IN OUT
15