Mitsubishi Electric DLP WD-52631 Owner's Manual page 59

Chapter 5. Operating Other Devices with the Remote Control 63
Programming the Remote Control
Method 1: Code Entry
1. Move the slide switch at the top of the remote to the
position for the product you want to control. Refer to
the table below. Only one of each device type can be
controlled in each slide-switch position.
CABLE/SAT Cable Box
DTV Receiver
Satellite Receiver
VOR VCR
DVR
Laser Disc Player
DVD Player/Recorder
DVD DVD Player/Recorder
DVR
Laser Disc Player
VCR
AUDIO A/V Receiver
Audio Amplifier
CD Player*
2. Press and hold POWER on the remote control for several
seconds until the button blinks twice and goes off.
3. Release the POWER button.
4. Enter the first five-digit code listed for your equipment.
• The POWER button blinks twice when you start to
enter the code and then once for each additional
keypress.
The POWER button blinks twice when you finish
entering a valid code.
Move the slide switch to another position if you
need to start over or wish to exit programming
mode.
5. Point the remote control at the equipment and press
POWER. If the product has no power on/off function,
press a different key, such as 1_ (PLAY), (_ (STOP),
VOL/x or MUTE,
= If the equipment responds, the remote control is
properly programmed to operate the equipment.
If the equipment does not respond, repeat steps
2-4 with the next five-digit code listed for your
equipment.
I: iMPORTANT
__ to reprogra m the remote
_ging the batteries.
6. Once you have found the correct code, write it in the
space below for future reference.
AUDIO
Method 2: Code Search
In this method of programming, you step through the
remote control's internal code library to find the correct
code for your A/V product.
1. Move the slide switch at the top of the remote control
to the correct position for the product. See the table
under "Method 1."
2. Press and hold POWER on the remote control for several
seconds until the button blinks twice and goes off.
3. Press keys 9 9 1
4. Press the number 1, 2, or 3 depending on the slide-
switch position and the table below.
5. Press OH/% and POWER repeatedly until the product
responds by powering on or off. You can press CHV
to move backward through the code library if needed.
NOTE: If the product has no power on/off function, check
for a response using a different function. Press
1_ (PLAY), (_ (STOP), VOL/x, or MUTE a nd then re-
peatedly press OH ix/V to check for a response.
6. When the product responds, press ENTER to set the
code.
Code Verification
To determine the code programmed for any position of
the slide switch:
1. Move the slide switch to the position you wish to
verify.
2. Press and hold POWER on the remote control for several
seconds until the button blinks twice and goes off.
3. Press keys 9 9 0
4. Press 1 and count the blinks of the power button.
Write down the number of blinks as the first digit of
the code.
5. Repeat step 4 for the second, third, fourth, and fifth
digits of the code.