Using The Remote Control - Mitsubishi CS-31301 Owner's Manual

Using the remote control
[:> Important:
Your TV conies with a remote control that not only operates your TV, but
can operate many of the functions of your VCR and cable box as well.
The remote control is pre-set to operate lqlitsubishi VCRs, but it can also
operate VCRs from other manufacturers as well, If you have a VCR from
another manufacturer, or if you have a cable box. it is advisable to "set
up" the remote control.
Each layer (VCR or AUX) can be set for either a cable box or a VCR,
setting up the remote control to operate your VCR
C) 'lhrn off your VCR,
(_ Set the TV/VCR/AUX switch to "VCR" or "AUX'.'
(_) 'While holding in the POWER button on the remote control, enter the
code number listed in the chart below for your brand of VCR, Be sure
to enter both digits of the code number. (If more than one code number
is listed, try the first one. If that code does not work, try the next one
until you find the correct code.)
If yourVCR
Is this
brand.,.
Mitaubishl (A]
Mitaublshi (B]
Canon
Emerson
Funal
GE
OoldS!,_r
Hitachi
JVC
Magnavox
Mullltech
NEC
Panasontc
Phllco
If yourVCR
,, .enter Is this ,..enter
this code brand.., this code
01 Philipa 03, 10,11
02 Quasar 03
03 RCA 08, 13, 20
04, 0S Sanyo 14
06 Scot 15
03 Sharp lS
07 8ony 17, 18
O0 Sylvania . 03, 10, 11
09 Symphonic 06
03, 10, ,It Tsknika 04, 06
06 Toshiba 15
12 Totevlaion 07
03 Zenith 19
03, 10
(_ Release the POWER button.
(_ Press the POWER button again. Your VCR should turn on. If the VCR
turns on, your remote control is now set to operate your VCR.
If your VCR does not turn on, repeat the instructions above, trying each
code number listed for your brand of VCR.
Getting Started 41