Mitsubishi CS-31301 Owner's Manual page 41

Setting up the remote control to operate your cable box
Important:
D Important:
@ Turn off you r cable box.
1_ Set theTV/VCR/AUX switch on the remote comrol to "AUX" or"VCR?
(_) While holding in the POWER button on the remote control, enter the code
number listed in the chart below for your brand of cable box. (If more than
one code number is listed, try the first one. if that code does not work, try
the next one until you find the correct code.)
If your
cable boxis ...enter
this brand,., thiscode
Zenith 51
Hamltn
Jerrold
(3.1
Oak
Pioneer
SA
52+ 53, 69
54, 57, 58, 59, CO,85
55, 56
01, 62, 82
64, 65, 84
el, B6
If your
cable boxIs .,.enter
thisbrand.., thiscode
Totem . 67,68
Panasonlc 63, 70
Ma¢om 71
Phillps 73, 74,75, 76, 77
Regency . 79
Tex_can 80
TCI
(closedcaptiondecoder = 83
Gemin+ 81
(_) Release the POWER button.
(_) Press the POWER button again, Your cable box should turn on. If the cable
box turns on, your remote control is now set to operate your cable box.
If your cable box does not turn on, repeat the instructions above, trying each
code number listed for your brand of cable box,
Sometimes manufacturers will change the remote control codes for their
products, or they use more than one code. If this is the case, your remote may not
be able to operate your VCR or cable box,
When you replace the batteries in your remote control, the remote will return to
its initial setting. The VCR layer will be set to control Mitsubishi (A) VCRs; the
AUX layer will be set to control Mitsubishi (B) VCRs. Repeat the steps above to
reset your remote control.
42 Chapter 3: Operating Your TV