Mitsubishi CS-31301 Owner's Manual page 32

procedure
(see illustration on the following page)
_-"Important
i _ Important:
0
0
0
0
Connect the incoming cable or antenna to ANTENNA IN terminal on
the VCR.
Connect one end of a coaxial cable to the ANTENNA OUT terminal
on the VCR,
Connect the other end of the cable to the antenna terminal on the TV.
Connect an RCA pin-type video cable to the VIDEO OUT terminal on
the back of the VCR, Connect the other end of this cable to the VIDEO
INPUT terminal on the back of the television.
If you are connecting a Super VHS (S-VHS) VCR, use a Super Video
cable instead of an RCA pin-type video cable, Connect a Super Video
cable to the S-VIDEO OUT terminal on the VCR. Connect the other
end of this cable to the S-VIDEO INPUT terminal on the back of the
television.
O Connect a set of RCA pin-type audio cables to the AUDIO OUTPUT
terminals on the back of the VCR. Use the red cable to connect the right
(R) channel and the white cable for connecting the left (L) channel.
Connect the other ends of this cable to the AUDIO INPUT terminals
on the back of the television,
If your VCR is monaural (non-stereo), you will only connect a single
RCA pin-type audio cable. Connect the cable to the VCR, then connect
the other end to the L (LEFT) audio input on the back of the television,
_l Set the VCR to the playback mode.
Select the external input source by using the INPUT button on the
front panel or rcmote control.
Basic Connections 33