Mitsubishi CS-31301 Owner's Manual page 35

TV + VCR + antenna or cable with a decoder box (cont.)
_> Important:
_" Important:
procedure
(See illustration on the following page.)
0
0
Connect the incoming cable t"o the IN terminal on the decoder box.
Connect a coaxial cable to the OUT terminal on the back of the decoder
box; connect the other end of this cable to the ANTENNA-IN terminal
on the back of the VCR.
O Connect the second coaxial cable to the ANTENNA-OUT terminal on
the back of the VCR. Connect the other end of this cable to the antenna
terminal on the back of the TV.
Connect an RCA pin-type video cable to the VIDEO OUT terminal on
the back of the VCR. Connect the other end of this cable to the VIDEO
INPUT terminal on the back of the television.
If you are connecting a Super VHS (S-VHS) VCR, use a Super Video cable
instead of an RCA pin-type video cable. Connect a Super Video cable to
the S-VIDEO OUT terminal on the VCR. Connect the other end of this
cable to the S-VIDEO INPUT terminal on the back of the television.
Connect a set of RCA pin-type audio cables to the AUDIO OUTPUT
terminals on the back of the VCR. Use the red cable to connect the
right (R) channel and the white cable for connecting the left (L) channel.
Connect the other ends of this cable to the AUDIO INPUT terminals
on the back of the television.
If your VCR is monaural (non-stereo), you will only connect a single RCA
pin-type audio cable. Connect the cable to the VCR, then connect the other
end to the L (LEFT) audio input on the back of the television.
Set the VCR to the playback mode.
Select the external input source by using the INPUTbuttnn on the front
panel or remote control.
36 Chapter 2: Connecling Your TV