Mitsubishi WS-73907 Owner's Manual page 21

Part I1: Installation
Connecting a DTV Receiver
DTV Receiver with RGB Video
Connections
(Figure 1)
TVba_kp_nel
:_i: _¸_¸¸_
I_c°mEng A_te_a,
_ID" er CabEe_
Figure I. Connecting the DTV receiver with RGB video
connections.
[] Connect the outside antenna, cable, or
satellite to ANT, or SATELLITE IN on the
DTV receiver (see your DTV receiver's
owner's guide for instructions, and cable
compatibility).
[] Connect the incoming terrestrial antenna,
or cable (not satellite) to ANT-A on the
TV back panel (a coaxial splitter, avail-
able at most electronic supply stores,
may be required to complete this instal-
lation).
[] Connect the RGB cables from the
DTV receiver to the HIGH RESOLU-
TION INPUT GRBHV on the TV back
panel. You may need to set the DTV
input assignment to RGB in the Assign
Input menu, page 33.
DTV Receiver TV Back Panel
[] G (green) = Y/G
[] R (red) = Pr/R
[] B (blue) = Pb/B
[]
If the DTV receiver has outputs for H
and V sync, connect as listed below
(DO NOT connect if DTV receiver uses
"Sync on Green"):
[] H (horizontal sync)=
[] V (vertical sync) =
H
V
[] Connect the L (left) and R (right) audio
cables from the DTV receiver and to
DTV AUDIO on the TV back panel.
[] To utilize the benefits of a digital A/V
receiver, connect your DTV receiver's
digital audio out to a digital input on your
digital A/V receiver.