Zenith P50W26 Installation And Operating Manual page 9

- To watcb digitally broadcast programs, purchase/connect adigital SET-TOP BOX.
How to connect a user-supp|ied Digital Set.Top Box
* Connect DTV set4op box video output to monitor COMPONENT (DVD/DTV INPUT) or to the monffor RGB1 (PC/DTV
iNPUT) connedor.
° Connect DTV set4op box audio outputs to monitor AUDIO INPUT jacks,
HOW tO use
1 Turn on the digital SET-TOP BOX. (Refer to the owner's ,manual for the digital SET-TOP BOX)
2 Use INPUT SELECT on the remote controt to select COM_N£NT or R_ 1
To enjoy vivid picture _d sound connect a PC to the Monitor.
Avoid keeping a fixed image on the monitor's screen for a tong period of time The fixed image may become permanent-
ty imprinted on the screen; use a screen saver when possible.
Connect PC to the RGBt INPUT(PC/DTV INPUT) or RGB2 INPUT(DIGITAL RGB _NPUT) port of the Monitor; change the
resolution output of PC accordingly.
Synchronization input form; Separate
Setup Instructions to Connect a PC to your Monitor
if the resolution of PC is over UXGA there will be no picture on time Monitor.
Connect the signa_ cable from the monitor output port of the PC to the RGB1 INPUT(PC/DTV iNPUT) port of the Monitor
or the signal cable from the DVI output port of the PC to the RGB2 iNPUT(DIGITAL RGB INPUT) port on time Monitor.
Connect the audio cable from the PC to time Audio input on the Monitor. (Audio cables are not included with the Monitor).
[f using a sound card adjust PC sound as required.
This monitor appty a VESA Plug and P_ay _Jution, When connecting a plug and play compatible system (PC) to the mon-
itor, additional settings are not necessary The monitor provides EDID data to the PC system with a DDC protocol The PC
adjusts automaticaJ[y to use this monitor.
DDC protoca[ is preset for RGB1 (Analog RGB) RGB2 (DV[, D,igir_l RGB) mode.
[f required adiust the monitor settings for P_ug and Pray functionally.
[f graphic card on the PC does net output analog and digital RGB simultaneousUy connect RGBt INPUT (PCiDTV tNPUT)
or RGB2 _NPUT (DIGITAL RGB iNPUT) port on the Monitor to the PC,
If graphic card on the PC does output analog and digital RG8 simultaneously set the monitor to either RGB1 or RGB2;
(the ether m_e is set to Plug and Pray automatically by the monitor.)
The monitor perceives 640x480, 60Hz as DTV 480p based on the PC graphic card. In this case change the screen scan-
ning rate for the graphic card
PC Setup
1. Turn on the PC and appEy power to the Monitor
2. Turn on the display by pressing the POWER button on the Monitor's remote control
3 Use the |NPUT SELECT but'ton on the remote control to select the RGB1 or RGB2 input source.
4 Set time resolution output of the PC to SXGA or under (1280 x 1024, 75Hz).