Furniture Or Projector Mounting; Power - Extron electronics IPL T SF24 Series User Manual

Installation and Operation, cont'd

Furniture or projector mounting

In addition to using the IPL T unit on a rack, it can also be
furniture or projector mounted. Furniture mount or projector
mount the interface using the optional mounting kit (Extron
part #70-212-01, furniture, or Extron part #70-217-01, projector)
as follows:
Attach the mounting brackets to the interface with the
1.
machine screws provided (figure 2-3).
2. If feet were previously installed on the bottom of the
interface, remove them.
3. For furniture mounting, hold the interface with the
attached brackets against the underside of the table or
other furniture. Mark the location of the screw holes of the
bracket on the mounting surface.
4. For furniture mounting, drill 3/32" (2 mm) diameter pilot
holes, 1/4" (6.3 mm) deep in the mounting surface at the
marked screw locations.
5. For furniture mounting, insert #8 wood screws into the
four pilot holes. Tighten each screw into the mounting
surface until just less than 1/4" of the screw head
protrudes.
6. For furniture mounting, align the mounting screws with
the slots in the brackets and place the interface against the
surface, with the screws through the bracket slots.
7. For furniture mounting, slide the unit slightly forward or
back, then tighten all four screws to secure it in place.
For projector mounting, secure the interface to a projector
8.
mount or other surface by inserting the mounting bolt
through the bracket's slotted hole.
Projector
Mounting
Mounting
Bolt
Bracket
Ceiling
Digital Projector
Projector Mount
Figure 2-3 — Mounting the IPL T SFI244
IPL T SF24 and IPL T SFI244 • Installation and Operation
2-4
Furniture Mount
IP L
T SF
I2 44
R
CO
M
IR TX
1 RX I/O
RT
2 S
CT IR
S
1
3
2
4
10 0
2 LI NK
4
AC
T
Rear Panel Features and Cabling
All connections, including power, input and output, and
control, are on the rear panel of the IPL T SF24 and IPL T SFI244.
See figures 2-4 and 2-5.
7
00-05-A6-00-00-01
LAN

POWER

I/O
12V
COM1
.5A MAX
1 2 3 4
TX RX
1 2 3
Figure 2-4 — IPL T SF24 rear panel
7
00-05-A6-00-06-25
FLEX I/O
POWER
LAN
12V
.5A MAX COM1 COM2 1
TX RX TX RX
1 4
2
Figure 2-5 — IPL T SFI244 Interface rear panel
Power
Power connection — Plug the external 12V power supply
1
into this connector. The power supply is included with the
unit.
CAUTION When connecting the power supply, voltage polarity
is extremely important. Applying power with
incorrect voltage polarity could damage the power
supply and the interface. Identify the power cord
negative lead by the ridges on the side of the cord.
IPL T SF24 and IPL T SFI244 • Installation and Operation
COM1
COM2
COM2
TX RX
4 5
IR
2 3 4 1 2 3 4
S G S G S G S G
3 6
2-5